1, before the test machine must be related to the installation, ready to do a good job. Do not say everything is ready to achieve no flaws. Can not run to the production line, and some preparatory work did not do well. For example, the preparation of the material to be pressed into the ball. Especially coal, but also need to add water, plus adhesive. So it is important to plan ahead to plan the installation of the machine and the preparation of the material.
2, the entire coal pressure ball machine installation of the work after the completion of the preparation. After starting the machine, be sure to idle a few minutes after the material. The significance of this process is that the running of the machine is preheated. And the problem can be timely repair in advance to solve. So that after the production, found that the problem to solve, very troublesome and inconvenient.
3, idle time without any problems and failures, you can carry out the production of the feed. Take the material production test machine is the best way to detect. Need to emphasize that is, must not be directly on the first material, and then start the coal pressure ball machine and other equipment. This will cause a huge load, there may be burned out of the motor and so on.
Previous: Description of the use of briquette pressure ball machine
Next: Improve the quality of coal briquette blasting machine has the following methods: